TPS92520EVM-074

Свойства продукта

Производитель:	Texas Instruments
Продукт:	Evaluation Modules
Тип продукта:	LED Lighting Development Tools

Отправить запрос

Категория: Texas Instruments

Описание
Отзывы (0)

Производитель:	Texas Instruments
Категория продукта:	LED Lighting Development Tools
Продукт:	Evaluation Modules
Рабочее напряжение питания:	4.5 V to 65 V
Бренд:	Texas Instruments
Output Current:	1.6 A
Тип продукта:	LED Lighting Development Tools
Заводская упаковка Количество:	1
Подкатегория:	Development Tools

Дополнительная информация

TPS92520EVM-074 Converter Evaluation Module

Texas Instruments TPS92520EVM-074 Converter Evaluation Module (EVM) features a two-phase, constant voltage (CV) boost regulator based on the TPS92682-Q1 dual channel controller. It powers two TPS92520-Q1 ICs, providing four current regulated channels of up to 1.6 Amps and 50W per channel (total output power limited to 100W). The TPS92520-Q1 and TPS92682-Q1 are controlled via a SPI interface. The Boost is designed to operate with an input voltage from 6V to 42V. It has a total power output of 100W with a maximum programmed output voltage of 50V. The Texas Instruments TPS92520EVM-074 is monitored and controlled via the serial interface bus by the required companion evaluation module (MSP-EXP432E401Y MCU LaunchPad™ Development Kit). The TPS92520-Q1 Evaluation Software provides a computer-based GUI, allowing users to control the buck output current(s), boost output voltage, and monitor the fault reporting features.

31FL323x LED Lighting Development Boards

ISSI 31FL323x LED Lighting Development Boards are development tools that evaluate ISSI multi-channel LED drivers. LED drivers are electrical circuits used to power light-emitting diodes. The fully assembled and tested board is powered by the Arm® Cortex®-M3 or 80C51 (IS31FL3235A-QFLS2-EB) with a 5V operating supply voltage. The evaluation boards have multiple display modes.

IS31LT3360 Demonstration Board

ISSI IS31LT3360 Demonstration Board is a fully assembled and tested PCB that uses the IS31LT3360 continuous mode inductive step-down converter. This ISSI board is designed to drive single or multiple series connected LEDs. This performance is achieved efficiently from a voltage source higher than the LED voltage.

IS31FL3236A-QFLS2-EB Evaluation Board

ISSI IS31FL3236A-QFLS2-EB Evaluation Board is a fully assembled and tested board that uses the IS31FL3236/IS31FL3236A LED lighting drivers. The IS31FL3236 / IS31FL3236A drivers comprise 36x constant current channels, each with independent PWM control and designed for driving LEDs. The output current of each channel can be set at up to 38mA (max.) by an external resistor and independently scaled by a factor of 1, 1/2, 1/3, and 1/4. The average LED current of each channel can be changed in 256x steps by changing the PWM duty cycle through an I²C interface.

Отзывы

Отзывов пока нет.