TPS92682QDAPRQ1

제품 속성

제조업체:	텍사스 인스트루먼트
시리즈:	TPS92682-Q1
패키지 / 케이스:	HTSSOP-32
채널 수:	2채널
제품:	Automotive LED Drivers
제품 유형:	LED Lighting Drivers

문의 보내기

카테고리: 텍사스 인스트루먼트

설명
상품평 (0)

제조업체:	텍사스 인스트루먼트
제품 카테고리:	LED Lighting Drivers
시리즈:	TPS92682-Q1
장착 스타일:	SMD/SMT
패키지 / 케이스:	HTSSOP-32
Number of Outputs:	2 Output
Output Current:	5 A
Topology:	Boost, Buck, Flyback, SEPIC
Operating Frequency:	100 kHz to 700 kHz
Output Voltage:	Adjustable
최소 작동 온도:	- 40 C
최대 작동 온도:	+ 125C
포장:	릴
포장:	테이프 자르기
Features:	Adjustable Switch Frequency, Synchronization Pin, Thermal Shutdown
브랜드:	텍사스 인스트루먼트
Dimming:	With Dimming
Input Voltage:	4.5 V to 65 V
습기에 민감합니다:	예
채널 수:	2채널
Output Type:	Open-Drain
제품:	Automotive LED Drivers
제품 유형:	LED Lighting Drivers
팩토리 팩 수량:	2000
하위 카테고리:	Driver ICs
Supply Current – Max:	10 mA

자세한 정보

IS32LT3175N/P Single-Channel Linear LED Drivers

ISSI IS32LT3175N/P Single-Channel Linear LED Drivers come with fade in/out and PWM dimming. The regulators serve as a stand-alone LED driver-configurable from 20mA to 150mA with external resistors, no microcontroller is necessary. A logic level “courtesy light” signal from the PWM pin can be interfaced to precisely drive the LED channel. The IS32LT3175P obtains a positive polarity PWM signal. In addition, the IS32LT3175N obtains a negative polarity PWM signal. The regulator integrates a 63-step fade-in and fades out the algorithm (Gamma correction). This causes the output LED current to increasingly rise up to the full source value after the EN pin is pulsed.

TPS92682-Q1 Peak Current-Mode Controller

Texas Instruments TPS92682-Q1 Dual-Channel Peak Current-Mode Controller is programmable to operate in constant-voltage (CV) or constant-current (CC) modes. In CV mode, the TPS92682-Q1 can be programmed to operate as two independent or dual-phase boost voltage regulators. The output voltage can be programmed using an external resistor voltage divider and a SPI-programmable 8-bit DAC. In CC mode, the device is designed to support dual-channel step-up or step-down LED driver topologies. LED current can be independently modulated using analog or PWM dimming techniques. Analog dimming with over 28:1 range is obtained using a programmable 8-bit DAC. PWM dimming of LED current is achieved either by directly modulating the PWM input pins with the desired duty cycle or using an SPI-programmable 10-bit PWM counter. The optional PDRV gate driver output can drive an external P-Channel series MOSFET.

상품평

아직 상품평이 없습니다.

TPS92682QDAPRQ1

자세한 정보

IS32LT3175N/P Single-Channel Linear LED Drivers

TPS92682-Q1 Peak Current-Mode Controller

상품평

“TPS92682QDAPRQ1”의 첫 상품평을 남겨주세요 응답 취소

연관 상품

로그인