SY89323LMG-TR

Valmistaja:	Microchip
Tuotekategoria:	CAN Interface IC
Sarja:	ATA6561
Tyyppi:	High Speed CAN Transceiver
Asennustapa:	SMD/SMT
Pakkaus / kotelo:	VDFN-8
Data Rate:	5 Mb/s
Number of Drivers:	1 Driver
Number of Receivers:	1 Receiver
Syöttöjännite - Min:	4.5 V
Syöttöjännite - Max:	5.5 V
Pienin käyttölämpötila:	- 40 C
Suurin käyttölämpötila:	+ 150 C
Operating Supply Current:	50 mA
ESD Protection:	8 kV
Pakkaus:	Kela
Pakkaus:	Leikkaa nauha
Pakkaus:	MouseReel
Tuotemerkki:	Microchip Technology
Liitäntätyyppi:	CAN
Kosteudelle herkkä:	Kyllä
Toimintajännite:	4.5 V to 5.5 V
Tuote:	CAN Transceivers
Tuotetyyppi:	CAN Interface IC
Propagation Delay Time:	300 ns
Tehdaspakkauksen määrä:	6000
Alaluokka:	Interface ICs
Yksikön paino:	0.005046 oz

Lisätietoja

Automotive Analog Products

Designers of electronic control modules within the automobile are being challenged to deliver increased performance in a variety of systems including powertrain, chassis, comfort, driver information, entertainment, and safety. Microchip Technology’s broad portfolio of low-power analog products enables the development of cost-effective solutions that address these challenges and others facing the system designer. As one of the first companies to apply Non-Volatile Memory (NVM) technology to the development process for analog products, Microchip has utilized its NVM experience to deliver innovative analog solutions with unchallenged electrical characteristics.

Functional Safety Solutions

Microchip Technology Functional Safety Solutions offer robustness, reliability, and safety to end-products. In some application segments, these requirements are formalized and mandatory, while in others, this is implemented to differentiate the product and take the step from a good product to an excellent product. The standards for functional safety depend on the market that is targeted. Many standards support multiple levels of rigorousness, which are applied depending on the likelihood and severity of the hazard. The methods of addressing hazards range from detecting single failures and putting the system into a safe state, to full redundancy where failures should not only be detected but also corrected without any interruption or degradation of service.

ATA6560/ATA6561 High-Speed CAN Transceivers

Microchip Technology ATA6560/ATA6561 High-Speed Controller Area Network (CAN) Transceivers provide an interface between a CAN protocol controller and the physical two-wire CAN bus. These high-speed CAN transceivers offer communication speeds up to 5Mbps. The ATA6560/ATA6561 transceivers offer improved Electromagnetic Compatibility (EMC) and Electrostatic Discharge (ESD) performance. These high-speed CAN transceivers feature a differential receiver with a wide common-mode range, remote wake-up capability via CAN bus, and functional behavior predictability under all supply conditions. The ATA6560/ATA6561 transceivers protect bus pins against transients in automotive environments.

Arviot

Tuotearvioita ei vielä ole.

SY89323LMG-TR

Lisätietoja

Automotive Analog Products

Functional Safety Solutions

ATA6560/ATA6561 High-Speed CAN Transceivers

Arviot

Kirjoita ensimmäinen arvio tuotteelle “SY89323LMG-TR” Peruuta vastaus

Tutustu myös

Kirjaudu sisään