NCV20074DTBR2G

Tootja:	onsemi
Tootekategooria:	Operational Amplifiers – Op Amps
Kanalite arv:	4 kanal
GBP – Gain Bandwidth Product:	3 MHz
SR – Slew Rate:	2.4 V/us
Vos – Input Offset Voltage:	1.3 mV
Ib – Input Bias Current:	1.5 nA
Toitepinge - Max:	36 V, +/- 18 V
Toitepinge - Min:	2.7 V, +/- 1.35 V
Töötav toitevool:	465 uA
Output Current per Channel:	65 mA
CMRR – Common Mode Rejection Ratio:	145 dB
en – Input Voltage Noise Density:	20 nV/sqrt Hz
Pakend / ümbris:	TSSOP-14
Paigaldamise stiil:	SMD/SMT
Sulgemine:	Väljalülitamist ei toimu
Minimaalne töötemperatuur:	- 40 C
Maksimaalne töötemperatuur:	+ 125 C
Seeria:	NCV20071
Kvalifikatsioon:	AEC-Q100
Pakend:	Reel
Pakend:	Lõigatud lint
Pakend:	MouseReel
3 dB Bandwidth:	–
Amplifier Type:	General Purpose Amplifier
Brändi:	onsemi
In – Input Noise Current Density:	90 fA/sqrt Hz
Ios – Input Offset Current:	200 pA
Maximum Dual Supply Voltage:	+/- 18 V
Minimum Dual Supply Voltage:	+/- 1.35 V
Väljundi tüüp:	Rail-to-Rail
Toode:	Operational Amplifiers
Toote tüüp: Toode:	Op Amps – Operational Amplifiers
PSRR – Power Supply Rejection Ratio:	135 dB
Tehase pakendi kogus:	2500
Alamkategooria:	Amplifier ICs
THD plus Noise:	0.001 %
Ühiku kaal:	0.006102 oz

Lisateave

NCS200x Rail-to-Rail Operational Amplifiers

onsemi NCS200x Rail-to-Rail Operational Amplifiers provide rail-to-rail output operation, and are available in single, dual, and quad configurations. Rail-to-rail operation enables the user to make optimal use of the entire supply voltage range while taking advantage of bandwidth. onsemi NCS200x can operate on supply voltages from 1.8V to 5.5V over the temperature range of −40°C to +125°C.

Current Sense Amplifiers

onsemi Current Sense Amplifiers monitor current consumption, providing critical information that can assist in the safety and diagnostic functions in a system. These Current Sense Amplifiers minimize BOM space and allow for system flexibility. They are low-cost, highly accurate, power-efficient, and offer minimal impact to battery life. onsemi offers cost-effective standalone Op-Amps and Current Sense Amplifiers that integrate external resistors to offer higher accuracy, smaller solution.

High Performance CMOS Operational Amplifiers

onsemi High-Performance CMOS Operational Amplifiers feature a wide range of general-purpose, low-power, and precision single, dual, and quad devices. The CMOS Op-Amps have the advantage of lower power and higher accuracy operation over traditional bipolar amplifiers, especially in terms of input bias current, quiescent current, and input offset voltage.

NCx2007x Operational Amplifiers

onsemi NCx2007x Operational Amplifiers provide rail-to-rail output operation, a 3MHz bandwidth, and single, dual, and quad configurations. The NCx2007x Op Amps operate on supply voltages as low as 2.7V over the temperature range of -40°C to +125°C. Rail-to-rail operation enables the user to use the entire supply voltage range optimally while taking advantage of 3MHz bandwidth. The high bandwidth on the device offers a slew rate of 2.8V/s while only consuming 405A of quiescent current per channel.

Industrial Motor Drives

onsemi Industrial Motor Drives are designed for global sustainability, supplying efficient, renewable technologies and intelligent power. According to the 2020 Motor System Market Analysis (MSMA), published by the US Department of Energy (DOE), industrial pumps and drives annually consume almost 15% of the total US grid. The 2020 MSMA also estimates that 32.3 million metric tons of CO₂ emissions can be saved annually using VFDs. onsemi manufactures a broad range of VFD semiconductor components, including gate drivers, MOSFETs, IGBTs, and EliteSiC.

Arvustused

Tooteülevaateid veel ei ole.